Putty Pads

1 2

Application: Penetrations
Fire Resistance Period: 120 minutes
Insulation/integrity: EI120
Test Standard: BS EN 1364:1 and BS EN 1363:1

Putty Pads are pre-cut ablative pads which have been specifically designed to reinstate the fire performance of the compartment wall when penetrated by electrical outlets, thereby reducing the need for additional backing materials. They provide a fast, efficient and clean method of achieving the required fire and acoustic ratings as required by Building Regulations Approved Documents.

Main Features Product Range Installation Instructions Testing & Certification Product Downloads

Main Features

Pre-cut putty pads designed to reinstate the fire performance of the compartment wall when penetrated by electrical outlets
They provide a fast, efficient and clean method of achieving the required fire performance
Can be moulded and used internally and externally around the electrical boxes
Coloured light red to indicate its fire capabilities
No mechanical fixings required

Field of Application

Can be used in masonry and plasterboard partitions up to 120minutes fire performance.
Can be used in conjunction with Metallic and Thermoplastic electrical switch boxes.
Suitable for use in single and double outlets.

Product Range

Part No	Size (mm) nominal dimensions	End use application	Pack size
PUTPAD170	170mm x 170mm x 3.25mm	Single outlet	20 units per box
PUTPAD230	230mm x 170mm x 3.25mm	Double outlet	20 units per box

All measurements are shown in millimetres [mm].

Installation Instructions

Internal

To achieve a high quality seal, ensure the socket is clean and free from any dirt, dust and that it is dry. Remove the protective film liner from the putty pad. Make a slit in the pad which will enable the cable to be passed through. Press the pad firmly into the socket recess ensuring full contact is made to all sides. Make sure the pad is not damaged or punctured during this process. Remove the remaining film liners and trim off any excess material to leave a neat finish.

External

To achieve a high quality seal, ensure the socket is clean and free from any dirt, dust and that it is dry. Remove the protective film liner from the pad. Mould the component around the extremities of the box to make an effective seal, trimming any excess of material.

Testing

The product has been tested in accordance with BS EN 1364-1 & BS EN 1363-1, achieving up to 120minutes fire resistance. Test report is available upon request.

Test Standard

BS EN 1364:1 & BS EN 1363-1

Product Downloads

Putty Pads Datasheet